student runs a TLC of a sample using a nonpolar development solvent. The TLC shows one spot. The MP of the same sample is 115.5 - 118.2 oC. What can we conclude from the experimental results. Group of answer choices The incorrect development solvent was used. The sample is pure. The sample is non polar. The sample is polar.

student runs a TLC of a sample using a nonpolar development solvent. The TLC shows one spot. The MP of the same sample is 115.5 - 118.2 oC. What can we conclude from the experimental results. Group of answer choices The incorrect development solvent was used. The sample is pure. The sample is non polar. The sample is polar.

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter31: Introduction To Analytical Separations

Section: Chapter Questions

Problem 31.5QAP

See similar textbooks

Similar questions

The following Rf values were computed from a normal phase chromatography experiment. Arrange them from most polar to least polar. I - 0.25 II - 0.84 III - 0.56 IV- 0.67 Group of answer choices II > IV > III > I I > III > IV > II I > II > III > IV IV > II > III > I
The following data were obtained from a Bradford assay to determine the protein content in a sample: Protein content (μg) Absorbance value 0 0.000 2 0.022 5 0.065 10 0.106 20 0.178 30 0.299 40 0.380 50 0.472 unknown 0.150 a. use excel, another program, or graph paper to produce a calibration curve based on the data. b. Use linear regression (best fit line) to obtain the slope of the line c. Determine the unknown protein content for a sample that shows an absorbance reading of 0.150.
How do you calculate the retention factor (Rf) for each spot ? Distance traveled by spot O 5.5cm Distance traveled by spot Y 4.0cm Distance traveled by spot G 3.0cm Distance traveled by solvent front 6.0cm
A 0.1 g amine-containing compound is dissolved in water then diluted to 100 mL. To get the concentration of amine in this compound, you subject it to spectroscopic analysis. So, you get 1 mL of the previously diluted sample then dilute it again to 250 mL for measurement. Then, you fill 3/4 of a 1-cm cuvette with this diluted sample then you run an analysis using an AAS. The recorded absorbance is 0.545 at 410 nm. Solve for the molecular weight of the compound. The molar absorptivity is 1.23 x 104 cm-1 mol-1 L.
A 0.1 g amine-containing compound is dissolved in water then diluted to 100 mL. You subject it to spectroscopic analysis, in order to get the concentration of amine in this compound. Next, you get 1 mL of the previously diluted sample then dilute it again to 250 mL for measurement. Then, you fill 3/4 of a 1-cm cuvette with this diluted sample, and you run an analysis using an AAS. The recorded absorbance is 0.545 at 410 nm. What is the molecular weight of the compound? (The molar absorptivity is 1.23 x 104 cm-1 mol-1 L.)
How can you use ion exchange Chromatography to de-ionize water? Please shortly write at your own words. (4-5 lines maximum ).
I have set up my spreadsheet and was able to reproduce the result with a pKa of 4.64. TRUE OR FALSE
I have set up my spreadsheet using this sample data and reproduced the result with a pKa of 4.64. true or false
Plant pigments in spinach were separated with TLC with cellulose as thestationary phase and 80/20 diethyl ether/acetone mixture as themobile phase. If needed, the solvent structures in the lab Appendix.1. Determine the Rf values of each plant component on this TLC plate.2. Arrange the plant components from most polar to most nonpolar. Please answer both 1 and 2 (picture below is the same question attached )
In a normal phase chromatography set up, the component that yields the highest Rf value is likely to be _____. Group of answer choices Both polarity Cannot be determined Polar Non-polar
The following Rf values were computed from a normal phase chromatography experiment. Arrange them from most polar to least polar. I - 0.25 II - 0.84 III - 0.56 IV- 0.67
Determine the concentration of linalool in a highly valued lavender essential oil. The peak areas of a series of standard solutions (calibrations standards) acquired from GC-MS (gas chromatography-mass spectrometry) is presented below. Concentration (mg/L) Peak area 0 201 25 5214 50 14658 75 23647 100 32657 125 42652 150 52478 QUESTION: Calculate the concentration of linalool in yourhighly valued lavender essential oil which returns a peak area of 27235.