Microelectronic Circuits (The Oxford Series in Electrical and Computer Engineering) 7th edition
7th Edition
ISBN: 9780199339136
Author: Adel S. Sedra, Kenneth C. Smith
Publisher: Oxford University Press
expand_more
expand_more
format_list_bulleted
Concept explainers
Question
Chapter 3, Problem 3.15P
To determine
The built-in voltage and the total charge stored.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
A solid square steel beam (E = 207 GPa) shall be used to support a platform for a harvest bucket, as shown below. With 2-m length of the beam, what size rectangular (1:2 height-to-width ratio) beam should be used to achieve 500 mu* m/m strain under maximum load of 100 kg? With 2.5 V excitation voltage (120 ohm strain gages with GF = 2.085, configured as a full bridge), what range (from no load to maximum load) of output voltage will be observed?
Find the resistance at 20 degrees Celcius of annealed copper bus bar 3.0 m in length and 0.5 cm by 3.0 cm in rectangular cross-section.
a) A light having an energy of 2.5 eV and power 8 mW illuminates a 0.3 μm thick semiconductor. If the absorption coefficient at the wavelength of light is 5.1x104 cm-1, calculate the number of photons per second will be emitted during the luminescence.
b) The n-side of a silicon p-n junction has a doping level 5 x 1016 cm-3. A forward bias of 0.70 V is applied on the p-n junction at T= 300 K. Calculate the minority carrier concentration at the edge of the depletion region.
Chapter 3 Solutions
Microelectronic Circuits (The Oxford Series in Electrical and Computer Engineering) 7th edition
Ch. 3.1 - Prob. 3.1ECh. 3.2 - Prob. 3.2ECh. 3.2 - Prob. 3.3ECh. 3.3 - Prob. 3.4ECh. 3.3 - Prob. 3.5ECh. 3.3 - Prob. 3.6ECh. 3.4 - Prob. 3.7ECh. 3.4 - Prob. 3.8ECh. 3.4 - Prob. 3.9ECh. 3.5 - Prob. 3.10E
Ch. 3.5 - Prob. 3.11ECh. 3.5 - Prob. 3.12ECh. 3.5 - Prob. 3.13ECh. 3.6 - Prob. 3.14ECh. 3.6 - Prob. 3.15ECh. 3.6 - Prob. 3.16ECh. 3 - Prob. 3.1PCh. 3 - Prob. 3.2PCh. 3 - Prob. 3.3PCh. 3 - Prob. 3.4PCh. 3 - Prob. 3.5PCh. 3 - Prob. 3.6PCh. 3 - Prob. 3.7PCh. 3 - Prob. 3.8PCh. 3 - Prob. 3.9PCh. 3 - Prob. 3.10PCh. 3 - Prob. 3.11PCh. 3 - Prob. 3.12PCh. 3 - Prob. 3.13PCh. 3 - Prob. 3.14PCh. 3 - Prob. 3.15PCh. 3 - Prob. 3.16PCh. 3 - Prob. 3.17PCh. 3 - Prob. 3.18PCh. 3 - Prob. 3.19PCh. 3 - Prob. 3.20PCh. 3 - Prob. 3.21PCh. 3 - Prob. 3.22PCh. 3 - Prob. 3.23PCh. 3 - Prob. 3.24PCh. 3 - Prob. 3.25PCh. 3 - Prob. 3.26PCh. 3 - Prob. 3.27PCh. 3 - Prob. 3.28PCh. 3 - Prob. 3.29P
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.Similar questions
- For a p-substrate silicon n-MOS capacitor at T=300 K, the substrate doping is NA= 4.25×10^16/cm 3 . The value of ni at T=300 K is 1.5×10^10/cm 3 . (I) What is bulk potential φB ?(ii) When the surface is inverted, what is the total surface band bending φs?(iii) For φm= 4.36 eV and X=4.01 eV, what is the flat band voltage VFB?(iv) Find the maximum depletion width ϗ(kai)DT (μm) when the surface is inverted.arrow_forwardb. A coaxial cable has inner radius of 1.2cm and outer radius of 1.8cm and has a length of 35m with an insulating material with relative permittivity 4.5. Calculate: i. Capacitance per meter. ii. Total Energy stored in the cable if a potential of 400v is applied across the cable.arrow_forwardFor a p-substrate silicon n-MOS capacitor at T=300 K, the substrate doping is NA= 4.25×10^16/cm 3 . The value of ni at T=300 K is 1.5×10^10/cm 3 . (I) What is bulk potential φB ?(ii) When the surface is inverted, what is the total surface band bending φs?(iii) For φm= 4.36 eV and ϗ=4.01 eV, what is the flat band voltage VFB?(iv) Find the maximum depletion width xDT (μm) when the surface is inverted.arrow_forward
- The conductor diameter of a single-core underground cable is 1cm and the inner sheath diameter is 1.8cm. Calculate the capacitance of the 1km-long cable in the case of using impregnated paper with a dielectric constant of 4 as the insulator.arrow_forwardThe outer radius of a coaxial cylindrical electrode system is given as 38 cm. The system is the most suitable sized according to puncture. Penetration of the insulator between the cylindrical layers Its strength is Ed = 78 kV / cm and the relative dielectric constant of the insulator is r1 = 40. a) - Calculate the capacity of the system and get the highest possible application without puncture to the system. Please respect what the voltage should be. b) - For the case of U = 180 kV application, the maximum and minimum occurrence on the system Calculate the electric field values? c) -Calculate the actual distance (d) of the system, the utilization factor (n) of the electrode aperture (alpha)? (Ɛ0 = 8,854x10-12 F / m)arrow_forwardQuestion 1.abc The transistor has beta= 120 and VBE= 0.7 V.It is known:The resistance RE= 1.2 kiloohms.At the same time the absolute potential at terminal A(+6V) and at terminal B(-6 V)For simplicity you can use IE aproximadamente IC.Analyze at DC and determine:a) The value of RB so that ICQ = 0.5 x ICsat.b) The value of VCEQ, considering section a).c) The absolute potential VEQ, considering section b).arrow_forward
- A Si sample is doped with donor impurities Np = 8*1016/cm3,then acceptor impurities are added with NA =8*1017/cm, We give: n; = 1010 / cm, q = 1.6*10-19 C, Hn 1350 cm?/V.s, Hp = 350 cm²/.s, Ep = 8.85*10-14 and € = 11.5, also kT = 26 meV and W = 0.36 um then: The conductivity of the n region on is: a. 172.8 1/(Ohm.cm) b. 44.8 1/(Ohm.cm) C. 4.48 1/(Ohm.cm) d. 17.28 1/(Ohm.cm)arrow_forwardIn a charge-free region for which σ = 0, = ₒr, and μ = μₒ, H = 5 cos (1011-4y) az A/m. find Jd, D and rarrow_forwardA 200 mm square single core copper conductor cable operating at 22kV, 50Hz has the following parrameters: external diameter of insulation, do = 73,5mm, diameter of conductor including area , di = 28,5mm. Calculate the dielectric loss of 1km length of cable if: I) The cable insulation is XPLE with er= 2,5 and tanr= 0.0003arrow_forward
- A rectangular aluminum bus bar is 0.9m long, 0.15 m wide, 0.013m (1.3cm) thick. If the current in the bus bar flows along its length, and the conductivity (σ) of aluminum is 3.57x10^8 S/m. Calculate the bus bar resistance in µΩ.arrow_forwardBelow is a schematic showing the cross-section of a Si n+ p junction solar cell. The area of the solar cell is 3 cm2 . Then n+ -type region is doped with a donor concentration ND = 2×1019 cm-3 and the p-type region is doped with an acceptor concentration NA = 1017 cm-3 . The intrinsic carrier concentration ni of Si at T = 300 K is 1.5x1010 cm-3 and the dielectric constant εr of Si is 12. In the conditions illustrated below, under AM1.5G illumination, the ammeter reads a current flow of 135 mA and the voltmeter reads a voltage of 0.62 V, respectively. a) Calculate the built-in potential Vbi of the p-n junction at 300 K in this solar cell. b) Calculate the depletion width W under thermal equilibrium at 300 K. c) Derive the expression of the power output as function of forward bias voltage V. d) Estimate the maximum power output.arrow_forwardBelow is a schematic showing the cross-section of a Si n+ p junction solar cell. The area of the solar cell is 3 cm2 . Then n+ -type region is doped with a donor concentration ND = 2×1019 cm-3 and the p-type region is doped with an acceptor concentration NA = 1017 cm-3 . The intrinsic carrier concentration ni of Si at T = 300 K is 1.5x1010 cm-3 and the dielectric constant εr of Si is 12. In the conditions illustrated below, under AM1.5G illumination, the ammeter reads a current flow of 135 mA and the voltmeter reads a voltage of 0.62 V, respectively. a) Estimate the maximum power output. b) Calculate the fill factor and power conversion efficiency of this solar cell. c) Assume a photovoltaic system consisting of such solar cell is installed in the rooftop of a house with an overall device active area of 30 m2 . The solar irradiation on the rooftop for each day is equivalent to 4 hours of AM1.5G illumination. Please estimate the total electricity generated annually (in kWh). xarrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Introductory Circuit Analysis (13th Edition)Electrical EngineeringISBN:9780133923605Author:Robert L. BoylestadPublisher:PEARSON
Delmar's Standard Textbook Of ElectricityElectrical EngineeringISBN:9781337900348Author:Stephen L. HermanPublisher:Cengage Learning
Programmable Logic ControllersElectrical EngineeringISBN:9780073373843Author:Frank D. PetruzellaPublisher:McGraw-Hill Education
Fundamentals of Electric CircuitsElectrical EngineeringISBN:9780078028229Author:Charles K Alexander, Matthew SadikuPublisher:McGraw-Hill Education
Electric Circuits. (11th Edition)Electrical EngineeringISBN:9780134746968Author:James W. Nilsson, Susan RiedelPublisher:PEARSON
Engineering ElectromagneticsElectrical EngineeringISBN:9780078028151Author:Hayt, William H. (william Hart), Jr, BUCK, John A.Publisher:Mcgraw-hill Education,
Introductory Circuit Analysis (13th Edition)
Electrical Engineering
ISBN:9780133923605
Author:Robert L. Boylestad
Publisher:PEARSON
Delmar's Standard Textbook Of Electricity
Electrical Engineering
ISBN:9781337900348
Author:Stephen L. Herman
Publisher:Cengage Learning
Programmable Logic Controllers
Electrical Engineering
ISBN:9780073373843
Author:Frank D. Petruzella
Publisher:McGraw-Hill Education
Fundamentals of Electric Circuits
Electrical Engineering
ISBN:9780078028229
Author:Charles K Alexander, Matthew Sadiku
Publisher:McGraw-Hill Education
Electric Circuits. (11th Edition)
Electrical Engineering
ISBN:9780134746968
Author:James W. Nilsson, Susan Riedel
Publisher:PEARSON
Engineering Electromagnetics
Electrical Engineering
ISBN:9780078028151
Author:Hayt, William H. (william Hart), Jr, BUCK, John A.
Publisher:Mcgraw-hill Education,