Concept explainers
Interpretation: The balanced net ionic equation should be written for the given precipitation reaction.
Concept introduction:
In a balanced equation the number of atoms of each element as a reactant is equal to the number of atoms of that element as a product.
Coefficient is a number placed before a formula in a chemical equation.
A balanced equation should be obeying the law of conservation of mass. “Law of conservation of mass” states that, the number of atoms remains constant throughout the reaction, simply it can be stated as follows, “during a
A precipitation reaction takes place when two solutions of well soluble substances together form a poorly soluble salt.
Ionic equation is an equation in which ions are explicitly shown.
Spectator ions are the ion that appears unchanged on both sides of a reaction arrow.
Net ionic equation is the chemical equation for a reaction which lists only those species participating in the reaction.
To write the net ionic equation, steps mentioned below must be followed.
- Write the balanced molecular equation
- Write the ionic equation showing the strong electrolytes completely dissociated into cations and anions.
- Cancel the spectator ions on both sides of the ionic equation.
- Check that charges and number of atoms are balanced in the net ionic equation.
Want to see the full answer?
Check out a sample textbook solutionChapter 5 Solutions
Pearson eText Fundamentals of General, Organic, and Biological Chemistry -- Instant Access (Pearson+)
- Consider the following pH titration curve of a diprotic acid. What is the approximate values for pka 1 and pka 2? the curve is attached below.arrow_forwardPropanamide and methyl acetate have about the same molar mass, both are quite soluble in water, and yet the boiling point of propanamide is 486 K, whereas that of methyl acetate is 330 K. Explain.arrow_forwardIn ion-exchange chromatography, amino acids are separated on the basis of electro-static interactions and hydrophobic interactions with the resin. The chemical structure of the resin pol-ymer with a negatively charged sulfonic acid group is shown to the right. An elution profile for the aminoacids using this resin is given below. Based on the elution profile above, explain the following:arrow_forward
- Discuss the suitability of bromocresol green and thymol blue (2nd change only) for use as indicators in an acetic acid - sodium hydroxide titration. Paragraph в I A + v ...arrow_forwardTirofiban (C22H36N₂O5S MWt = 440.6) is present as tirofiban HCI monohydrate (C22H36N2O5S.HCI.H₂O MWt=495.1) at 0.281 mg/mL in a concentrated solution. A solution for infusion is prepared by extracting 50 mL from a 250 mL bag of 5% glucose solution and adding 50 mL of concentrated solution. Sofia who weighs weighs 87 kg requires a tirofiban dose of 0.1 mcg/kg/min for 12 to 24 hours. What would the infusion rate be (mL/h)? (Answer to 1 decimal place.) Answer:arrow_forwardIn the electrolysis of aqueous sodium bromide, there are two possible anodic reactions: *2H2O(l) ——-> 02(g) + 4H+(aq) + 4e–, E° = 1.23V2Br–(aq) ——–> Br2(g) + 2e-2, E° = 1.08 VWhich reaction occurs at anode and why?arrow_forward
- Potentiometric titration curve is given below, which is obtained during the potentiometric titration between strong base KOH (0.2 M) with strong acid HI, label the point in the curve from the following options. If more than one points are present than write as x, y(means separate by using comma) a)The point where pH is because of excess OH - ions. b) The point where pH is only because of HI in water. c)The point where [HI]= [I] in water. d)The point where pH=pka e) The point where all HI is neutralized. f) The point where pH corresponds to solution of [I- ] in water. 14 13 12 11 10 9 pH 6. TITIT TITarrow_forwardGive full reaction for the synthesis of Diclofenac sodium ?arrow_forwardGlycine hydrochloride (Cl− H3N+CH2COOH) is a diprotic acid that contains a carboxylic acid group and an ammonium group and is therefore called an amino acid. It is often used in biochemical buffers. Solve, In analogy with Figure , sketch the titration curve of this diprotic acid.arrow_forward
- A 1.000-g sample containing bromide was dissolved in sufficient water to give 100.0 mL. A 50.00 mL aliquot was measured and after acidification, silver nitrate was introduced to precipitate AgBr, which was filtered, washed, and then dissolved in an ammoniacal solution of potassium tetracyanonickelate(II): Ni(CN)42- + 2AgBr(s) → 2Ag(CN)2- + Ni2+ + 2Br- The liberated nickel ion required 11.70 mL of 0.002146 M EDTA. The other 50.00 mL remaining solution was also analyzed for its Br- content by potentiometry using a metallic electrode of the second kind. e) Write the cell notation of the potentiometric set-up with SCE as the reference electrode. f) Write the Nernst equation that describes the indicator electrode set-up.arrow_forwardDetermine the weight/volume of the chemicals needed to prepare the following solutions: a) 100 ml of 0.9% (w/v) saline (NaCl) b) 30 ml of 50% glycerol (v/v) c) Electrophoresis requires TAE, which is a specific mixture of Tris base, acetic acid, and EDTA. TAE is normally made as a 50X concentrated stock. Provide a recipe to make 40 ml of 50X TAE. The recipe for one liter of 50X TAE is as follows: 242g Tris base, 57.1 ml glacial acetic acid, 100 ml 0.5 M EDTAarrow_forwardThe isoelectric point of eIF4a is 5.02. Students are given a sample of cell lysate containing eIF4A at pH 7.4. They are also provided with two buffers of pH 7.4 to use for ion exchange chromatography. One buffer has a very high salt concentration (1 M), the other has a low salt concentration (0.1 M). Mariela decides to use an anion exchange column, while Ashok chooses a cation exchange column. Who made the better decision? Provide a detailed explanation of why one student will end up with a purer sample of eIF4A. Which buffer will you use while washing away impurities (high or low salt), and which would you use to remove eIF4A from the column? Explain your choice.arrow_forward