Consider the following XRD diffractogram of a sand sample and reference mineraldiffractograms:ASand Samplen CalciteDolomiteMagnesite,101214161820222420(°)The sand sample contains (select all that apply):MagnesiteCalciteDolomiteIntensity

Given is the XRD diffractogram of a sand sample, and reference minerals.

Consider the following XRD diffractogram of a sand sample and reference mineral diffractograms: A Sand Sample Calcite Dolomite Magnesite, 10 12 14 16 18 20 22 24 20(°) The sand sample contains (select all that apply): Magnesite Calcite Dolomite Intensity

Consider the following XRD diffractogram of a sand sample and reference mineral diffractograms: A Sand Sample Calcite Dolomite Magnesite, 10 12 14 16 18 20 22 24 20(°) The sand sample contains (select all that apply): Magnesite Calcite Dolomite Intensity

Principles of Modern Chemistry

8th Edition

ISBN:9781305079113

Author:David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Publisher:David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Chapter22: Inorganic Materials

Section: Chapter Questions

Problem 40AP

See similar textbooks

Related questions

Q: When using a multimeter as a conductivity meter, what are the units used?

A: Electrical conductivity is a fundamental property of material which signifies that how strongly it…

Q: A water sample was analyzed for Fe content using the iron-phenanthroline method. The following data…

Q: A solution of potassium permanganate of unknown concentration was analyzed against a standard of…

A: To calculate the value of unknown concentration, we must generate a calibration curve in which known…

Q: AG° is independent of temperature. TRUE FALSE

A: The standard gibbs free energy is the function of temperature.

Q: Microstructure of a steel contain 100% coarse pearlite it carbon content is reported to be 0.65% is…

A: Given : Coarse pearlite mass percent = 100 % And mass percent of carbon i.e carbon content = 0.65 %…

Q: Which of the following will cause an instrumental deviation in Beers Law? I. stray light II.…

A: Answer Which of the following will cause an instrumental deviation in…

Q: Explain how XPS can be used to identify the compositions of the material in the layers below the…

Q: Ca+2 = 36.8mg/L Mg+2 = 2.9mg/L HCO3 = 98mg/L pH = 7.53 Temp = 9 degree Celsius…

Q: Formation water contains 10,000 ppm of NaCL, 15,000 ppm of MGSO4 and 8,000 ppm of CaCl2 . Calculate…

A: The answer is attached below-

Q: the moment of mixing. If, by chance, a pre 10-11. Given this information, will a precipi cause Q =…

A: Given, Molarity of Mg(NO3)2 = 1.38×10-4 M Molarity of NaF = 1.76 ×10-4 M Solubility equilibrium…

Q: Rank the following iron–carbon alloys and associated microstructures from the highest to the lowest…

Q: explain the relationship between the refractice index of a mixture and the molar fractions of the…

A: The detailed solution of your question given below-- Since, we know that how to find mole fraction…

Q: sing the lead-lin phase diagram in gure or a nominal composition of 90 % Sn and 10 % Pb at 204 °C.…

A: Solution -

Q: Referring to the Al-Si Eutectic diagram discussed on the Phase Diagrams-Lever Rule handout,…

Q: 4.Magnetic property Ir°: (Xe) 6s² 4f14 5d7 [Ir(NO2)613- [ Select ] [IrBr3- 5. Both [Ni(CN)4]²- and…

A: 4. (II)

Q: A single crystal Ni (in FCC) alloy bar is uniaxially pulled along [-123]. The bar starts to yield at…

Q: 2. Calculate solubility parameter for linear PVC and linear Poly-ethylene using group attraction…

A: The enthalpy change on mixing of a polymer and a solvent, whole volume of the solution, volume…

Q: You are centrifuging a test tube of spherical cells in a buffer solution. The buffer viscosity and…

A: Given: Viscosity of buffer=0.02 Pa.s Diameter of cell=4.5 μm Density of cell=1.2 g/cm3 Density of…

Q: What effect does decreasing the stationary phase film thickness have on the terms of the van Deemter…

Q: 7.25 The lower yield point for an iron that has an average grain diameter of 1 x 10-2 mm is 230 MPa…

A: In this case, the grain diameter at which the lower yield point will be 310 MPa needs to be…

Q: Which of the following characteristics of a reversed – phase chromatography? I. The stationary…

A: In reversed-phase chromatography is a liquid chromatography technique that involves the separation…

Q: Standard Tubes Volume of 0.1 Hydroxamate standard Tubes Optical Density (OD) Concentration 0.061…

A: Interpretation: To write the conclusion of the result given.

Q: 1. What is the function of a liquid junction? 2. What causes the potential difference at the liquid…

A: Hi, we are supposed to answer one question. To get the remaining questions solved please mention the…

Q: substance classification (check all that apply) 1000X 10,000,000X Ogas Oliquid normal Osolid…

A: Sketch of a substance.

Q: Clark's method.

A: Clark's method removes the hardness of water by converting bicarbonates into carbonate.

Q: Stainless steel typically contains 1% carbon, 1-5% manganese, 0.05% phosphorus, 1-3% silicon, 5-10%…

A: Stainless-steel is a commonly used alloy of iron, carbon and some other metals. Each element have to…

Q: What is the stationary phase in thin layer chromatography and its polarity? Choices: Cellulose -…

A: In thin layer chromatography(TLC) silica is used as stationary phase. Silica is a polar adsorbent .

Q: Chromate-dichromate system 1. Prepare a clean spot plate and label four wells. Place 5 drops of 0.…

A: To complete the table with observations:

Q: n simple words, describe the following steps in fabricating an IC: a- Crystal growth; b-…

A: Die preparation is one of the major concerns during semiconductor chip fabrication. Wafer mounting,…

Q: 1000 912 sio 700 s00 400 Weighs Pere Siver For an alloy containing 20 wt % Ag, refer to the Cu-Ag…

Q: What is the narrow graduated piece of glass equipment called? Why do you use an Erlenmeyer flask…

A: 1) A volumetric flask (measuring flask or graduated flask) is a piece of laboratory apparatus, a…

Q: In normal phase liquid chromatography, the general elution problem can be solved by: _ using a more…

A: The general elution problem in normal phase liquid chromatography can be solved by

Q: 4.Determination of hardness by clark's test

A: Hardness of water is caused by the the dissolved calcium and magnesium ions present in the water.…

Q: You have 3 compounds (A, B, C) in your samples. Their polarity A > B > C. You want to separate these…

A: In HPLC technique, the separation of components on basis of polarity, size, charge takes place. The…

Q: A solution of potassium chromate of unknown concentration was analyzed against a standard of various…

A: A question based on absorption that is to be accomplished.

Q: which of the four binary mobile phase compositions (mixing ratio 1: 1) shown below will have the…

A: The polar and non-polar compounds are: Non-polar - Pentane, toluene. Polar - Methanol, acetone,…

Q: 7. The lattice constants of GaAs:Px alloys are continuously tunable from 5.43 Å (pure GaP) to 5.65Å…

A: Given, the lattice parameter of pure GaP is 5.43 angstorm.the lattice parameter of pure GaAs is 5.65…

Q: an X-ray diffraction pattern for a powder sample of Cr (crystal system: body-centered cubic and…

A: Given: The wavelength of the radiation is 0.1542 nm. The lattice parameter is 0.2884 nm. The value…

Q: A small piece of Fe-0.4 wt%C alloy is held at 728°C for 1 hour and then quenched. On microstructure…

A: At 728 °C 1. Proeutectoid fermite 2. Austenite phase will present On quenching Austenite will be…

Q: 6.1) At the composition of 0.77% by weight C, identify the phase(s) present at 950 degrees C 6.2)…

A: Since you have asked multiple subparts in the question, we will answer the first three subparts of…

Q: Missing molar conductivity Given: Conductivity: 281 us x cm^-1 (microseconds/cm) Concentration of…

Q: A researcher wants to calculate the flux of palm oil (PO) in a simulated body fluid (SBF). To…

A: Here this problem is the diffusion of Palm oil (PO) from the stock solution (10 g PO/ lit SBF) to…

Q: data tables show the time between mixing and the color change for two sets of conditions. und…

A: Dear student I have given answer to your question in the image format .

Q: A water sample was analyzed for Fe content using the iron-phenanthroline method. The following data…

A: Volume of Stock Solution (mL) Total Volume of Standard Solution (mL) Concentration of Standard…

Q: Explain each in 5 sentences Paper Chromatography- Thin layer Chromatography- Column…

A: Chromatography is used to seprate the mixture and to purify the compounds. First three given are the…

Q: -17 The diffusivity of silver in solid silver metal is 1.0 x 10 m -13 2 Is at 500°C and 7.0 x 10 m…

A: Given, The diffusivity of silver in solid silver metal = 1.0 × 10^-17 m2/s at 500 degree Celsius.…

Q: Determine whether the first part of statement will INCREASE, DECREASE or have NO EFFECT in the…

A: 1 Overall charge remain constant 2 decrease The higher the molecular weight the greater the…

Concept explainers

Crystallography

Crystallography is the category of science that focuses on the atomic and molecular arrangements with their bonding constituting the crystal structure. It is derived experimentally and originated in the year 1912. It is a combination of two words; those are crystal, meaning a cold drop, and graph, meaning writing.

Question

Consider the following XRD diffractogram of a sand sample and reference mineral
diffractograms:
A
Sand Sample
n Calcite
Dolomite
Magnesite,
10
12
14
16
18
20
22
24
20(°)
The sand sample contains (select all that apply):
Magnesite
Calcite
Dolomite
Intensity

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

(i) Write the type of magnetism observed when the magnetic moments are aligned in parallel and anti-parallel directions in unequal numbers.(ii) Which stoichiometric defect decreases the density of the crystal?
Determine the repeat distance, linear density, and packing fraction for FCC nickel, which has a lattice parameter of 0.35167 nm, in the [100], [ 110], and [111] directions. Which of these directions is closen packed?
In the iron-carbon alloy phase diagram as shown in Fig. 1, draw the microstructures with indicating the name of each phases existing at (a) - (h) point.
Please use phase diagram to explain why micro-segregation and macro-segregation happen during practical solidification.
A crystal has a cubic unit cell of 4.2 Å. Using a wavelength of 1.54 Å at which 2θ value would you expect tomeasure the (111) peak?
2)The cubic unit cell parameter (a) of polonium (α-Po) is 335 pm. Use the Goldschmidt correction (Table 1) to calculate a metallic radius for this element.
If you are given a fully labeled hypoeutectoid TTT diagram and the associated Fe-C phase diagram, is it possible to determine the average composition of the Fe-C alloy? If so, how?
The addition of dimethylglyoxime, H2C4H602N2, to a solution containing nickel(Il) ion gives rise to a precipitate: Nickel dimethylglyoxime is a bulky precipitate that is inconvenient to manipulate in amounts greater than 135 mg. The amount of nickel in a type of permanent-magnet alloy ranges between 22% and 38%. Calculate the sample size that should not be exceeded when analyzing these alloys for nickel.
Lattice parameters of α and β phases were calculated from x-ray diffraction measurements performed in A-B alloys with different compositions, all quenched from 500, 600 and 700 °C. Draw a schematic A-B phase diagram using this information
Cu and Ni form a substitutional solidsolution. This means that the crystal structureof a Cu-Ni alloy consists of Ni atomssubstituting for Cu atoms in the regularatomic positions of the FCC structure. Fora Cu-30% wt.% Ni alloy, what fraction ofthe atomic sites does Ni occupy?
1) For a crystalline substance with a hexagonal unit cell, the distance interplanar d is given by the expression. Consider graphite, for which a = 0.247 nm and c = 0.679 nm. On a standardized diffractogram with Cu Kα radiation ((λ = 1.5418 Å)), where angle 2θ will be observed the Bragg 002 peak of graphite?
A crystal of FeO was found to have a unit cell dimension of 4.501Å, a measured density of 5.828 x10^3 kg/m3 and an iron to oxygen ratio of 0.945. Determine whether the defect in this sample is due to iron vacancies or interstitial oxygens. Solve