An Introduction to Thermal Physics
1st Edition
ISBN: 9780201380279
Author: Daniel V. Schroeder
Publisher: Addison Wesley
expand_more
expand_more
format_list_bulleted
Concept explainers
Question
Chapter 5.4, Problem 65P
To determine
The variation of the phase diagram for a system having a substantial positive mixing energy so that its free energy curve is much flatter.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
Why do the collisions between molecules do not appear in the derivation of the ideal gas law?
Under what conditions is the ideal-gas assumption suitable for real gases?
ILLUSTRATE THE PROBLEM ONLY!!!
5 moles of cinnamaldehyde gas that has an initial volume of ten liters expands under the following conditions: 185°F and 800mmHg external pressure.
a. How much work is done? Express your answer in L atm.
b. Assuming that the container is cylindrical with a base radius of 10cm and can only expand vertically, how much kinetic energy does a single molecule possesses if it travels from base to base of the expanded cylinder in 10μs? Express your answer in J.
ILLUSTRATE THE PROBLEM ONLY!!!
Chapter 5 Solutions
An Introduction to Thermal Physics
Ch. 5.1 - Prob. 1PCh. 5.1 - Consider the production of ammonia from nitrogen...Ch. 5.1 - Prob. 3PCh. 5.1 - Prob. 4PCh. 5.1 - Consider a fuel cell that uses methane (natural...Ch. 5.1 - Prob. 6PCh. 5.1 - The metabolism of a glucose molecule (see previous...Ch. 5.1 - Derive the thermodynamic identity for G (equation...Ch. 5.1 - Sketch a qualitatively accurate graph of G vs. T...Ch. 5.1 - Suppose you have a mole of water at 25C and...
Ch. 5.1 - Suppose that a hydrogen fuel cell, as described in...Ch. 5.1 - Prob. 12PCh. 5.1 - Prob. 13PCh. 5.1 - Prob. 14PCh. 5.1 - Prob. 15PCh. 5.1 - Prob. 16PCh. 5.1 - Prob. 17PCh. 5.2 - Prob. 18PCh. 5.2 - In the previous section 1 derived the formula...Ch. 5.2 - Prob. 20PCh. 5.2 - Is heat capacity (C) extensive or intensive? What...Ch. 5.2 - Prob. 22PCh. 5.2 - Prob. 23PCh. 5.3 - Go through the arithmetic to verify that diamond...Ch. 5.3 - Prob. 25PCh. 5.3 - How can diamond ever be more stable than graphite,...Ch. 5.3 - Prob. 27PCh. 5.3 - Calcium carbonate, CaCO3, has two common...Ch. 5.3 - Aluminum silicate, Al2SiO5, has three different...Ch. 5.3 - Sketch qualitatively accurate graphs of G vs. T...Ch. 5.3 - Sketch qualitatively accurate graphs of G vs. P...Ch. 5.3 - The density of ice is 917kg/m3. (a) Use the...Ch. 5.3 - An inventor proposes to make a heat engine using...Ch. 5.3 - Below 0.3 K the Slope of the 3He solid–liquid...Ch. 5.3 - Prob. 35PCh. 5.3 - Effect of altitude on boiling water. (a) Use the...Ch. 5.3 - Prob. 37PCh. 5.3 - Prob. 38PCh. 5.3 - Prob. 39PCh. 5.3 - The methods of this section can also be applied to...Ch. 5.3 - Suppose you have a liquid (say, water) in...Ch. 5.3 - Ordinarily, the partial pressure of water vapor in...Ch. 5.3 - Assume that the air you exhale is at 35C, with a...Ch. 5.3 - Prob. 44PCh. 5.3 - Prob. 46PCh. 5.3 - Prob. 47PCh. 5.3 - Prob. 48PCh. 5.3 - Prob. 49PCh. 5.3 - The compression factor of a fluid is defined as...Ch. 5.3 - Prob. 51PCh. 5.3 - Prob. 52PCh. 5.3 - Repeat the preceding problem for T/Tc=0.8.Ch. 5.3 - Prob. 54PCh. 5.3 - Prob. 55PCh. 5.4 - Prove that the entropy of mixing of an ideal...Ch. 5.4 - In this problem you will model the mixing energy...Ch. 5.4 - Suppose you cool a mixture of 50% nitrogen and 50%...Ch. 5.4 - Suppose you start with a liquid mixture of 60%...Ch. 5.4 - Suppose you need a tank of oxygen that is 95%...Ch. 5.4 - Prob. 62PCh. 5.4 - Everything in this section assumes that the total...Ch. 5.4 - Figure 5.32 shows the phase diagram of plagioclase...Ch. 5.4 - Prob. 65PCh. 5.4 - Prob. 66PCh. 5.4 - Prob. 67PCh. 5.4 - Plumbers solder is composed of 67% lead and 33%...Ch. 5.4 - What happens when you spread salt crystals over an...Ch. 5.4 - What happens when you add salt to the ice bath in...Ch. 5.4 - Figure 5.35 (left) shows the free energy curves at...Ch. 5.4 - Repeat the previous problem for the diagram in...Ch. 5.5 - If expression 5.68 is correct, it must be...Ch. 5.5 - Prob. 74PCh. 5.5 - Compare expression 5.68 for the Gibbs free energy...Ch. 5.5 - Seawater has a salinity of 3.5%, meaning that if...Ch. 5.5 - Osmotic pressure measurements can be used to...Ch. 5.5 - Because osmotic pressures can be quite large, you...Ch. 5.5 - Most pasta recipes instruct you to add a teaspoon...Ch. 5.5 - Use the Clausius–Clapeyron relation to derive...Ch. 5.5 - Prob. 81PCh. 5.5 - Use the result of the previous problem to...Ch. 5.6 - Prob. 83PCh. 5.6 - Prob. 84PCh. 5.6 - Prob. 85PCh. 5.6 - Prob. 86PCh. 5.6 - Sulfuric acid, H2SO4, readily dissociates into H+...Ch. 5.6 - Prob. 88PCh. 5.6 - Prob. 89PCh. 5.6 - When solid quartz dissolves in water, it combines...Ch. 5.6 - When carbon dioxide dissolves in water,...Ch. 5.6 - Prob. 92P
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- If one kind of molecule has double the radius of another and eight times the mass, how do their mean free paths under the same conditions compare? How do their mean free times compare?arrow_forwardIn the text, it was shown that N/V=2.681025m3 for gas at STP. (a) Show that this quantity is equivalent to N/V=2.681019cm3, as stated. (b) About how many atoms are mere in one m3 (a cubic micrometer) at STP? (c) What does your answer to part (b) imply about the separation of Mama and molecules?arrow_forward3. 0.5 moles of cinnamaldehyde gas that has an initial volume of ten liters expands under the followingconditions: 185°F and 800mmHg external pressure.a. How much work is done? Express your answer in L atm.b. Assuming that the container is cylindrical with a base radius of 10cm and can only expandvertically, how much kinetic energy does a single molecule possesses if it travels from baseto base of the expanded cylinder in 10μs? Express your answer in J.arrow_forward
- Hi, could I get some help with this micro-macro connection physics problem involving root mean square speed? The set up is: What is the rms speed (in m/s) of a helium-3 atom in an ideal gas at a room temperature of 300 kelvin (K) to 4 digits of precision if kB = 1.38e-23 J/K, and the mass of helium-3 is 3.016 u, where the atomic mass unit u = 1.66e-27 kg? Thank you.arrow_forwardHi, could I get some help with this micro-macro connection physics problem involving root mean square speed? The set up is: For an atom in an ideal gas with rms speed in one direction, vx = 100 m/s, and mass m = 6.66e-27 kg, what is the temperature T in kelvin (K) to four digits of precision if Boltzman constant kB = 1.38e-23 J/K? Thank you.arrow_forwardAn altitude of 150 km is the lowest altitude where a satellite could successfully orbit the earth.At 150 km, the pressure is about 3 x 10-6torr and the temperature is roughly 250 K. Assuming, forsimplicity, that the air consists entirely of oxygen, calculate the mean free path under theseconditions. What is the average collision frequency?arrow_forward
- What are the key principles and applications of the adiabatic approximation in the field of physics?arrow_forwardIf you have 9 moles of a monoatomic ideal gas, how much heat is required to raise the temperature of this gas from 264.3K to 277.6K if the volume of the gas remains constant during the heating? Note: It is understood that your answer is in units of Joulesarrow_forwardIn this problem you are to consider an adiabaticexpansion of an ideal diatomic gas, which means that the gas expands with no addition or subtraction of heat. Assume that the gas is initially at pressure p0, volume V0, and temperature T0. In addition, assume that the temperature of the gas is such that you can neglect vibrational degrees of freedom. Thus, the ratio of heat capacities is γ=Cp/CV=7/5. Note that, unless explicitly stated, the variable γshould not appear in your answers--if needed use the fact that γ=7/5 for an ideal diatomic gas. Find an analytic expression for p(V), the pressure as a function of volume, during the adiabatic expansion. Express the pressure in terms of V and any or all of the given initial values p0, T0, and V0. p(V) = __________arrow_forward
- In this problem you are to consider an adiabaticexpansion of an ideal diatomic gas, which means that the gas expands with no addition or subtraction of heat. Assume that the gas is initially at pressure p0, volume V0, and temperature T0. In addition, assume that the temperature of the gas is such that you can neglect vibrational degrees of freedom. Thus, the ratio of heat capacities is γ=Cp/CV=7/5. Note that, unless explicitly stated, the variable γshould not appear in your answers--if needed use the fact that γ=7/5 for an ideal diatomic gas. A) Find an analytic expression for p(V), the pressure as a function of volume, during the adiabatic expansion. Express the pressure in terms of V and any or all of the given initial values p0, T0, and V0. p(V) = __________ B) At the end of the adiabatic expansion, the gas fills a new volume V1, where V1>V0. Find W, the work done by the gas on the container during the expansion. Express the work in terms of p0, V0, and V1. Your…arrow_forwardIf one kind of molecule has double the radius of another and eight times the mass, how do their mean free paths under the same conditions compare? How do their mean free times compare?arrow_forward‼️Illustrate the problem ONLY: A rubberized sphere contains carbon dioxide. If the initial radius of the sphere is 15cm: a. How much work is done if the carbon dioxide-filled sphere expanded to five times its original volume against the pressure at STP? Express your answer in L atm. b. Upon the expansion of the sphere, what is the kinetic energy of a single carbon dioxide molecule if it travels across the diameter and covers it in 30ms? Assume that the sphere contains one mole of carbon dioxide. Express your answer in J. b. How much power can all the molecules in this sphere generate after 30s? Assume that the sphere contains one mole of carbon dioxide and that all molecules have the same kinetic energy. Express your answer in W. (Use the KE obtained from the previous required)‼️Illustrate the problem ONLYarrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Modern PhysicsPhysicsISBN:9781111794378Author:Raymond A. Serway, Clement J. Moses, Curt A. MoyerPublisher:Cengage LearningCollege PhysicsPhysicsISBN:9781938168000Author:Paul Peter Urone, Roger HinrichsPublisher:OpenStax College
Modern Physics
Physics
ISBN:9781111794378
Author:Raymond A. Serway, Clement J. Moses, Curt A. Moyer
Publisher:Cengage Learning
College Physics
Physics
ISBN:9781938168000
Author:Paul Peter Urone, Roger Hinrichs
Publisher:OpenStax College