An Introduction to Thermal Physics
1st Edition
ISBN: 9780201380279
Author: Daniel V. Schroeder
Publisher: Addison Wesley
expand_more
expand_more
format_list_bulleted
Concept explainers
Question
Chapter 5.3, Problem 46P
(a)
To determine
The total Gibbs free energy of the system.
(b)
To determine
The expression for
(c)
To determine
The variation of
(d)
To determine
The critical equilibrium radius and the relation between chemical potential and relative humidity.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
A molecule has states with the following energies: 0, 1ε, 2ε, 3ε, and 4ε, where ε = 1.0 x 10-20 J.
Calculate the average number of molecules in the first excited state (1ε) for a collection of 1000 molecules in thermal equilibrium at T = 300 K.
Note that the average number of molecules in a state is just the probability that a molecule is in the state times the number of molecules.
Provide your answer as a number in normal form.
With reference to the potential energy between two carbon atoms, explain why, in stating that diamond appears to be stable at room temperature and pressure.
Use a computer to reproduce the table and graph in Figure 2.4: two Einstein solids, each containing three harmonic oscillators, with a total of six units of energy. Then modify the table and graph to show the case where one Einstein solid contains six harmonic oscillators and the other contains four harmonic oscillators (with the total number of energy units still equal to six). Assuming that all microstates are equally likely, what is the most probable macrostate, and what is its probability? What is the least probable macrostate, and what is its probability?
Chapter 5 Solutions
An Introduction to Thermal Physics
Ch. 5.1 - Prob. 1PCh. 5.1 - Consider the production of ammonia from nitrogen...Ch. 5.1 - Prob. 3PCh. 5.1 - Prob. 4PCh. 5.1 - Consider a fuel cell that uses methane (natural...Ch. 5.1 - Prob. 6PCh. 5.1 - The metabolism of a glucose molecule (see previous...Ch. 5.1 - Derive the thermodynamic identity for G (equation...Ch. 5.1 - Sketch a qualitatively accurate graph of G vs. T...Ch. 5.1 - Suppose you have a mole of water at 25C and...
Ch. 5.1 - Suppose that a hydrogen fuel cell, as described in...Ch. 5.1 - Prob. 12PCh. 5.1 - Prob. 13PCh. 5.1 - Prob. 14PCh. 5.1 - Prob. 15PCh. 5.1 - Prob. 16PCh. 5.1 - Prob. 17PCh. 5.2 - Prob. 18PCh. 5.2 - In the previous section 1 derived the formula...Ch. 5.2 - Prob. 20PCh. 5.2 - Is heat capacity (C) extensive or intensive? What...Ch. 5.2 - Prob. 22PCh. 5.2 - Prob. 23PCh. 5.3 - Go through the arithmetic to verify that diamond...Ch. 5.3 - Prob. 25PCh. 5.3 - How can diamond ever be more stable than graphite,...Ch. 5.3 - Prob. 27PCh. 5.3 - Calcium carbonate, CaCO3, has two common...Ch. 5.3 - Aluminum silicate, Al2SiO5, has three different...Ch. 5.3 - Sketch qualitatively accurate graphs of G vs. T...Ch. 5.3 - Sketch qualitatively accurate graphs of G vs. P...Ch. 5.3 - The density of ice is 917kg/m3. (a) Use the...Ch. 5.3 - An inventor proposes to make a heat engine using...Ch. 5.3 - Below 0.3 K the Slope of the 3He solid–liquid...Ch. 5.3 - Prob. 35PCh. 5.3 - Effect of altitude on boiling water. (a) Use the...Ch. 5.3 - Prob. 37PCh. 5.3 - Prob. 38PCh. 5.3 - Prob. 39PCh. 5.3 - The methods of this section can also be applied to...Ch. 5.3 - Suppose you have a liquid (say, water) in...Ch. 5.3 - Ordinarily, the partial pressure of water vapor in...Ch. 5.3 - Assume that the air you exhale is at 35C, with a...Ch. 5.3 - Prob. 44PCh. 5.3 - Prob. 46PCh. 5.3 - Prob. 47PCh. 5.3 - Prob. 48PCh. 5.3 - Prob. 49PCh. 5.3 - The compression factor of a fluid is defined as...Ch. 5.3 - Prob. 51PCh. 5.3 - Prob. 52PCh. 5.3 - Repeat the preceding problem for T/Tc=0.8.Ch. 5.3 - Prob. 54PCh. 5.3 - Prob. 55PCh. 5.4 - Prove that the entropy of mixing of an ideal...Ch. 5.4 - In this problem you will model the mixing energy...Ch. 5.4 - Suppose you cool a mixture of 50% nitrogen and 50%...Ch. 5.4 - Suppose you start with a liquid mixture of 60%...Ch. 5.4 - Suppose you need a tank of oxygen that is 95%...Ch. 5.4 - Prob. 62PCh. 5.4 - Everything in this section assumes that the total...Ch. 5.4 - Figure 5.32 shows the phase diagram of plagioclase...Ch. 5.4 - Prob. 65PCh. 5.4 - Prob. 66PCh. 5.4 - Prob. 67PCh. 5.4 - Plumbers solder is composed of 67% lead and 33%...Ch. 5.4 - What happens when you spread salt crystals over an...Ch. 5.4 - What happens when you add salt to the ice bath in...Ch. 5.4 - Figure 5.35 (left) shows the free energy curves at...Ch. 5.4 - Repeat the previous problem for the diagram in...Ch. 5.5 - If expression 5.68 is correct, it must be...Ch. 5.5 - Prob. 74PCh. 5.5 - Compare expression 5.68 for the Gibbs free energy...Ch. 5.5 - Seawater has a salinity of 3.5%, meaning that if...Ch. 5.5 - Osmotic pressure measurements can be used to...Ch. 5.5 - Because osmotic pressures can be quite large, you...Ch. 5.5 - Most pasta recipes instruct you to add a teaspoon...Ch. 5.5 - Use the Clausius–Clapeyron relation to derive...Ch. 5.5 - Prob. 81PCh. 5.5 - Use the result of the previous problem to...Ch. 5.6 - Prob. 83PCh. 5.6 - Prob. 84PCh. 5.6 - Prob. 85PCh. 5.6 - Prob. 86PCh. 5.6 - Sulfuric acid, H2SO4, readily dissociates into H+...Ch. 5.6 - Prob. 88PCh. 5.6 - Prob. 89PCh. 5.6 - When solid quartz dissolves in water, it combines...Ch. 5.6 - When carbon dioxide dissolves in water,...Ch. 5.6 - Prob. 92P
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- The v = 0 to v = 1 vibrational transition of the HI molecule occurs at a frequency of 6.69 × 1013 Hz. The same transition for the NO molecule occurs at a frequency of 5.63 × 1013 Hz. Calculate (a) the effective force constant and (b) the amplitude of vibration for each molecule. (c) Explain why the force constant of the NO molecule is so much larger than that of the HI molecule.arrow_forwardConsider two immiscible liquids such as water and oil. If a spherical oil molecule of radius r is taken out of the oil phase and placed in the water phase, the unfavorable energy of this transfer is proportional to the area of the solute (oil) molecule newly exposed to the solvent (water) multiplied by the interfacial energy, i, of the oil-water interface. The interfacial energy of the bulk cyclohexane-water interface is i = 50 mJ m-2, and the radius of a cyclohexane molecule is 0.28 nm. Using Boltzmann distribution, estimate the solubility of cyclohexane in water at 25 C in units of mol L-1.The concentration of water in water phase is 55.5 mol L-1.arrow_forwardHi, could I get some help with this micro-macro connection physics problem involving root mean square speed? The set up is: For an atom in an ideal gas with rms speed in one direction, vx = 100 m/s, and mass m = 6.66e-27 kg, what is the temperature T in kelvin (K) to four digits of precision if Boltzman constant kB = 1.38e-23 J/K? Thank you.arrow_forward
- What properties of a nonideal gas do the van der Waals constants a and b represent?arrow_forwardShow complete and step by step solution. Show the illustrations of the given situation.arrow_forwardAccording to a new spectroscopy analysis, the adjacent bond vectors was found to be A = 1.07i + 0.83j + 0.81k B = 1.03i + -0.99j + -0.85k What is the angle (in degrees) between the bonds based on this new data?arrow_forward
- When are the rotational degrees of freedom of a diatomic molecule expected to contribute R to the molar constant volume heat capacity? When will a vibrational degree of freedom contribute R to the molar heat capacity?arrow_forwardA rigid tank of volume V = 0.014 m3 contains carbon monoxide at a temperature of T0 = 25° C and a pressure of P0 = 9.00 × 105 Pa. This molecule should be treated as a diatomic ideal gas with active vibrational modes. Part (a) In this model, how many degrees of freedom does each molecule of carbon monoxide have? Part (b) The temperature of the gas increases by 10° C. Select the process that has occurred from the choices below. Part (c) Calculate the pressure of the gas in pascal at this increased temperature. Part (d) Calculate the change to the internal energy of the gas in joules. Part (e) Calculate the change in the entropy of the gas in joules per kelvin. I know you cannot answer all parts however manyuo can will helparrow_forwardHow do I solve this problem properly in a step by step solution?arrow_forward
- What is the minimum energy required to go from one vibrational state to the next higher vibrational state for a molecule whose vibrations are modeled by a harmonic oscillator?arrow_forwardCalculate the number of microstates that are available in a single atom of carbon in graphite.The standard molar entropy (S°) of carbon is 5.7 J/(mol · K) and the Boltzmann constant (kB) is1.381 × 10 ―23?/?. HELP PLEASEarrow_forwardOne description of the potential energy of a diatomic molecule is given by the Lennard–Jones potential, U = (A)/(r12) - (B)/(r6)where A and B are constants and r is the separation distance between the atoms. Find, in terms of A and B, (a) the value r0 at which the energy is a minimum and (b) the energy E required to break up a diatomic molecule.arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Modern PhysicsPhysicsISBN:9781111794378Author:Raymond A. Serway, Clement J. Moses, Curt A. MoyerPublisher:Cengage Learning
Modern Physics
Physics
ISBN:9781111794378
Author:Raymond A. Serway, Clement J. Moses, Curt A. Moyer
Publisher:Cengage Learning