Organic Chemistry
9th Edition
ISBN: 9781305080485
Author: John E. McMurry
Publisher: Cengage Learning
expand_more
expand_more
format_list_bulleted
Question
Chapter 14.SE, Problem 44AP
Interpretation Introduction
Interpretation:
Given that 1,3-cyclopentadiene polymerizes slowly at room temperature to yield a
Concept introduction:
Conjugated dienes polymerise through the 1,4 addition of one diene molecule to another diene molecule.
To propose:
A structure for the polymer obtained by the slow
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
One common type of cation exchange resin is prepared by polymerization of a mixture containing styrene and 1,4-divinylbenzene . The polymer is then treated with concentrated sulfuric acid to sulfonate a majority of the aromatic rings in the polymer.
Q.) Show the product of sulfonation of each benzene ring.
The cationic polymerization of isobutylene (2-methylpropene) is shown in Section 8-16A. Isobutylene is often polymer- ized under free-radical conditions. Propose a mechanism for the free-radical polymerization of isobutylene.
Give the structural formula of A, B & C
Give the reagents and reaction conditions for the steps labelled v, x, w & y
Chapter 14 Solutions
Organic Chemistry
Ch. 14.1 - Prob. 1PCh. 14.2 - Give the structures of both 1, 2 and 1, 4 adducts...Ch. 14.2 - Prob. 3PCh. 14.2 - Give the structures of both 1, 2 and 1, 4 adducts...Ch. 14.3 - Prob. 5PCh. 14.3 - Prob. 6PCh. 14.5 - Predict the product of the following Diels–Alder...Ch. 14.5 - Prob. 8PCh. 14.5 - Which of the following dienes have an s-cis...Ch. 14.5 - Predict the product of the following Diels–Alder...
Ch. 14.6 - Prob. 11PCh. 14.6 - Prob. 12PCh. 14.7 - Prob. 13PCh. 14.7 - Prob. 14PCh. 14.8 - Which of the following compounds would you expect...Ch. 14.SE - Prob. 16VCCh. 14.SE - Show the product of the Diels–Alder reaction of...Ch. 14.SE - Prob. 18VCCh. 14.SE - Prob. 19VCCh. 14.SE - Prob. 20MPCh. 14.SE - Prob. 21MPCh. 14.SE - In light of your answer to Problem 14-21 propose...Ch. 14.SE - Luminol, which is used by forensic scientists to...Ch. 14.SE - Prob. 24MPCh. 14.SE - Give IUPAC names for the following compounds:Ch. 14.SE - Prob. 26APCh. 14.SE - Prob. 27APCh. 14.SE - Electrophilic addition of Br2 to isoprene...Ch. 14.SE - Prob. 29APCh. 14.SE - Prob. 30APCh. 14.SE - Predict the products of the following...Ch. 14.SE - 2,3-Di-tert-butyl-1,3-butadiene does not undergo...Ch. 14.SE - Prob. 33APCh. 14.SE - Prob. 34APCh. 14.SE - Prob. 35APCh. 14.SE - Prob. 36APCh. 14.SE - Rank the following dienophiles in order of their...Ch. 14.SE - Prob. 38APCh. 14.SE - Prob. 39APCh. 14.SE - Prob. 40APCh. 14.SE - Although the Diels–Alder reaction generally...Ch. 14.SE - Prob. 42APCh. 14.SE - Tires whose sidewalls are made of natural rubber...Ch. 14.SE - Prob. 44APCh. 14.SE - Prob. 45APCh. 14.SE - Prob. 46APCh. 14.SE - Would you expect allene, H2C = C = CH2, to show a...Ch. 14.SE - The following ultraviolet absorption maxima have...Ch. 14.SE - Prob. 49APCh. 14.SE - -Ocimene is a pleasant-smelling hydrocarbon found...Ch. 14.SE - Draw the resonance forms that result when the...Ch. 14.SE - Prob. 52APCh. 14.SE - Treatment of 3,4-dibromohexane with strong base...Ch. 14.SE - Prob. 54APCh. 14.SE - Prob. 55APCh. 14.SE - Prob. 56APCh. 14.SE - Prob. 57APCh. 14.SE - Prob. 58APCh. 14.SE - Hydrocarbon A, C10H14, has a UV absorption at...Ch. 14.SE - Prob. 60APCh. 14.SE - Prob. 61APCh. 14.SE - Prob. 62APCh. 14.SE - Prob. 63APCh. 14.SE - Prob. 64APCh. 14.SE - The double bond of an enamine (alkene + amine) is...Ch. 14.SE - Prob. 66AP
Knowledge Booster
Similar questions
- Bicyclo-2,5-heptadiene can be prepared in two steps from cyclopentadiene and vinyl chloride. Provide a mechanism for each step.arrow_forwardThe cationic polymerization of isobutylene (2-methylpropene) is shown in Section 8-16A. Isobutylene is often polymerized under free-radical conditions. Propose a mechanism for the free-radical polymerization of isobutylene.8arrow_forwardA boron-siloxane cross linked polymer was formed from the reaction between dichlorodimethylsilane in diethyl ether with deionised water. Which was neutralised with sodium bicarbonate solution before being turned into a polymer upon the addition of boric acid. What is the structure of the polymer synthesised and what is the molecular weight of one monomer unit of this boron-siloxane cross linked polymer?arrow_forward
- 4. The following reaction scheme shows the radical polymerization of styrene to make polystyrene. a) Add electron-pushing arrows to show the mechanisms of steps 1-3. Determine if these are initiation, propagation, or termination steps. b) Radical polymerization is often performed in the absence of O2 because the oxygen radical can couple with the polymer radical to terminate polymerization. Propose electron-pushing arrows for step 4 and predict the product of that step.arrow_forwardGive a single benefit for each polymerisation from carrying them out under a nitrogen atmosphere? (d) Of the two polymers produced (A and B) one had Mn = 12,000 and a polydispersity of 1.1 and one a Mn = 11, 200 and a polydispersity of 1.7. Identify which set of molecular weight parameters corresponds to which polystyrene sample.arrow_forwardThe polymer shown below is synthesized by hydroxide ion-promoted hydrolysis of a copolymer of para-nitrophenyl methacrylate and acrylate. a. Propose a mechanism for the formation of the copolymer. b. Explain why hydrolysis of the copolymer to form the polymer occurs much more rapidly than hydrolysis of para-nitrophenyl acetate.arrow_forward
- What is the thermodynamic product obtained from the addition of 1 equivalent of HBr to 1,3-butadiene?arrow_forwardHow can head-to-head poly(vinyl bromide) be synthesized? head-to-head poly(vinyl bromide)CH2CHCHCH2CH2CHCHCH2Br Br Br Brarrow_forwardSuggest which of the following monomers might polymerize well on treatment with BF3. (a) vinyl chloride (b) vinyl acetate (c) methyl a-cyanoacrylatearrow_forward
- Concerning the polymers produced from monomers containing a single C=C double bond, the following generalizations are apparent: (a) The polymers produced are almost always unsubstituted (i.e. ethylene) or have one substituent on the double bond or two substituents on the same carbon atom of the double bond. Monomers containing one or more substituents on each carbon of the double bond seldom polymerize. (b) Most chain polymerizations are carried out by radical initiation; relatively few are produced by ionic initiation. Why? Explain the reasons for these generalizationsarrow_forwardEpoxy adhesives are prepared in two steps. SN2 reaction of the disodium salt of bisphenol A with epichlorohydrin forms a prepolymer, which is then cured by treatment with a triamine such as H2NCH2CH2NHCH2CH2NH2. Draw structures to show how addition of the triamine results in a strengthening of the polymer.arrow_forward9a. Give a complete reaction scheme for the polymerization of styrene with tert-butylhydroperoxide as an initiator and termination by disproportionate.arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- EBK A SMALL SCALE APPROACH TO ORGANIC LChemistryISBN:9781305446021Author:LampmanPublisher:CENGAGE LEARNING - CONSIGNMENTOrganic ChemistryChemistryISBN:9781305580350Author:William H. Brown, Brent L. Iverson, Eric Anslyn, Christopher S. FootePublisher:Cengage Learning
EBK A SMALL SCALE APPROACH TO ORGANIC L
Chemistry
ISBN:9781305446021
Author:Lampman
Publisher:CENGAGE LEARNING - CONSIGNMENT
Organic Chemistry
Chemistry
ISBN:9781305580350
Author:William H. Brown, Brent L. Iverson, Eric Anslyn, Christopher S. Foote
Publisher:Cengage Learning