(a) To estimate: The synthesis gas reaction on the process Concept introduction: In gasification process, carbon reacts with steam and produce carbon monoxide and hydrogen which are known as synthesis gas. This may either burned or subjected for further process to produce variety of chemicals.

Question

Want to see the full answer?

Answer 1

Question

Chapter 9, Problem 9.45P

Interpretation Introduction

(a)

To estimate:

The synthesis gas reaction on the process

Concept introduction:

In gasification process, carbon reacts with steam and produce carbon monoxide and hydrogen which are known as synthesis gas. This may either burned or subjected for further process to produce variety of chemicals.

Interpretation Introduction

(b)

To estimate:

The expression for molar flow rate for four outlet gas.

Concept introduction:

When moles of mixture pass the measurement point in one second, it is called molar flow rate which is denoted as n.

Interpretation Introduction

(c)

To Estimate:

The heat of formation of coal

Concept introduction:

The sum of internal energy and the product of the pressure and volume of a thermodynamic system are known as enthalpy

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

Solid calcium (CaF2) reacts with sulfuric acid to form solid calcium sulfate and gaseous hydrogen fluoride. The HF is then dissolved in water to form hydrofluoric acid. A source of calcium fluoride is fluorite ore containing 96 wt% CaF2 and 4% SiO2. In a typical hydrofluoric acid manufacturing process, fluorite ore is reacted with 93 wt% aqueous sulfuric acid, supplied 15% in excess of the stoichiometric amount. Ninety-five percent of the ore dissolves in the acid. Some of the HF formed reacts with the dissolved silica in the reaction 6 HF + SIO2 (aq) – H2SİF6 (9) + 2 H2O (1) The hydrogen fluoride exiting from the reactor is subsequently dissolved in enough water to produce 60 wt% hydrofluoric acid. Calculate the quantity of fluorite ore needed to produce a metric ton of acid. Express your answer into three significant figures.

In a chemical production plant, cyclohexane is made by the reaction of benzene and hydrogen. Reaction is as follows: CHs + H2 → CoH12 The complete process of producing cyclohexane uses a reactor and a separator. Using the process shown below and assuming 20 % excess hydrogen in the fresh feed, find the ratio of the recycle stream to the fresh feed stream, the composition of the final product stream, and the composition of the stream leaving the reactor. The overall conversion of benzene is 92% and the single-pass conversion is 21.5 %. The recycle stream is composed of 23.9 % benzene and the remaining hydrogen. Fresh Feed REACTOR SEPARATOR Product Recycle

Methanol (CH3OH) is produced in the reaction of carbon dioxide and hydrogen via the reaction and process given below: CO2+3H2→CH3OH+H2O The fresh feed to the process contains hydrogen, carbon dioxide, and 0.400 mol% inerts (I). The reactor effluent passes through a condenser that removes essentially all of the methanol and water formed and none of the reactants or inerts. The unreacted reactants and inerts are recycled to the reactor. To avoid buildup of the inerts in the system, a purge stream is withdrawn from the recycle. 100 mol/h of feed to the reactor (not the fresh feed to the process) contains 29.5 mol% CO2, 68.0 mol% H2, and 2.50 mol% inerts. The single-pass conversion of hydrogen is 46.71%. What is the recycle-to-fresh feed ratio?

Answer 2

Question

Chapter 9, Problem 9.45P

Interpretation Introduction

(a)

To estimate:

The synthesis gas reaction on the process

Concept introduction:

In gasification process, carbon reacts with steam and produce carbon monoxide and hydrogen which are known as synthesis gas. This may either burned or subjected for further process to produce variety of chemicals.

Interpretation Introduction

(b)

To estimate:

The expression for molar flow rate for four outlet gas.

Concept introduction:

When moles of mixture pass the measurement point in one second, it is called molar flow rate which is denoted as n.

Interpretation Introduction

(c)

To Estimate:

The heat of formation of coal

Concept introduction:

The sum of internal energy and the product of the pressure and volume of a thermodynamic system are known as enthalpy

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Answer 3

Question

Chapter 9, Problem 9.45P

Interpretation Introduction

(a)

To estimate:

The synthesis gas reaction on the process

Concept introduction:

In gasification process, carbon reacts with steam and produce carbon monoxide and hydrogen which are known as synthesis gas. This may either burned or subjected for further process to produce variety of chemicals.

Interpretation Introduction

(b)

To estimate:

The expression for molar flow rate for four outlet gas.

Concept introduction:

When moles of mixture pass the measurement point in one second, it is called molar flow rate which is denoted as n.

Interpretation Introduction

(c)

To Estimate:

The heat of formation of coal

Concept introduction:

The sum of internal energy and the product of the pressure and volume of a thermodynamic system are known as enthalpy

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Answer 4

Question

Chapter 9, Problem 9.45P

Interpretation Introduction

(a)

To estimate:

The synthesis gas reaction on the process

Concept introduction:

In gasification process, carbon reacts with steam and produce carbon monoxide and hydrogen which are known as synthesis gas. This may either burned or subjected for further process to produce variety of chemicals.

Interpretation Introduction

(b)

To estimate:

The expression for molar flow rate for four outlet gas.

Concept introduction:

When moles of mixture pass the measurement point in one second, it is called molar flow rate which is denoted as n.

Interpretation Introduction

(c)

To Estimate:

The heat of formation of coal

Concept introduction:

The sum of internal energy and the product of the pressure and volume of a thermodynamic system are known as enthalpy

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Answer 5

Chapter 9, Problem 9.45P

Interpretation Introduction

(a)

To estimate:

The synthesis gas reaction on the process

Concept introduction:

In gasification process, carbon reacts with steam and produce carbon monoxide and hydrogen which are known as synthesis gas. This may either burned or subjected for further process to produce variety of chemicals.

Interpretation Introduction

(b)

To estimate:

The expression for molar flow rate for four outlet gas.

Concept introduction:

When moles of mixture pass the measurement point in one second, it is called molar flow rate which is denoted as n.

Interpretation Introduction

(c)

To Estimate:

The heat of formation of coal

Concept introduction:

The sum of internal energy and the product of the pressure and volume of a thermodynamic system are known as enthalpy

Answer 6

Chapter 9, Problem 9.45P

Interpretation Introduction

(a)

To estimate:

The synthesis gas reaction on the process

Concept introduction:

In gasification process, carbon reacts with steam and produce carbon monoxide and hydrogen which are known as synthesis gas. This may either burned or subjected for further process to produce variety of chemicals.

Answer 7

Chapter 9, Problem 9.45P

Interpretation Introduction

(a)

To estimate:

The synthesis gas reaction on the process

Concept introduction:

In gasification process, carbon reacts with steam and produce carbon monoxide and hydrogen which are known as synthesis gas. This may either burned or subjected for further process to produce variety of chemicals.

Answer 8

Interpretation Introduction

(b)

To estimate:

The expression for molar flow rate for four outlet gas.

Concept introduction:

When moles of mixture pass the measurement point in one second, it is called molar flow rate which is denoted as n.

Answer 9

Interpretation Introduction

(b)

To estimate:

The expression for molar flow rate for four outlet gas.

Concept introduction:

When moles of mixture pass the measurement point in one second, it is called molar flow rate which is denoted as n.

Answer 10

Interpretation Introduction

(c)

To Estimate:

The heat of formation of coal

Concept introduction:

The sum of internal energy and the product of the pressure and volume of a thermodynamic system are known as enthalpy

Answer 11

Interpretation Introduction

(c)

To Estimate:

The heat of formation of coal

Concept introduction:

The sum of internal energy and the product of the pressure and volume of a thermodynamic system are known as enthalpy

Answer 12

Expert Solution & Answer

Answer 13

Expert Solution & Answer

Answer 14

Want to see the full answer?

Check out a sample textbook solution

See solution

Answer 15

Ch. 9 - The standard heat of the reaction...Ch. 9 - Prob. 9.2P Ch. 9 - Prob. 9.3P Ch. 9 - The standard heat of the reaction...Ch. 9 - Prob. 9.5P Ch. 9 - Prob. 9.6P Ch. 9 - Prob. 9.7P Ch. 9 - Prob. 9.8P Ch. 9 - The standard heat of combustion of gaseous ethane...Ch. 9 - The standard heat of combustion (AH°) of liquid...

(a) To estimate: The synthesis gas reaction on the process Concept introduction: In gasification process, carbon reacts with steam and produce carbon monoxide and hydrogen which are known as synthesis gas. This may either burned or subjected for further process to produce variety of chemicals.

Solution Summary: The author explains the synthesis gas reaction on the process. Carbon reacts with steam and produces carbon monoxide and hydrogen.

Concept explainers

(a)

To estimate:

The synthesis gas reaction on the process

Concept introduction:

In gasification process, carbon reacts with steam and produce carbon monoxide and hydrogen which are known as synthesis gas. This may either burned or subjected for further process to produce variety of chemicals.

(b)

To estimate:

The expression for molar flow rate for four outlet gas.

Concept introduction:

When moles of mixture pass the measurement point in one second, it is called molar flow rate which is denoted as n.

(c)

To Estimate:

The heat of formation of coal

Concept introduction:

The sum of internal energy and the product of the pressure and volume of a thermodynamic system are known as enthalpy

Want to see the full answer?

Chapter 9 Solutions

(a) To estimate: The synthesis gas reaction on the process Concept introduction: In gasification process, carbon reacts with steam and produce carbon monoxide and hydrogen which are known as synthesis gas. This may either burned or subjected for further process to produce variety of chemicals.

Solution Summary: The author explains the synthesis gas reaction on the process. Carbon reacts with steam and produces carbon monoxide and hydrogen.

Concept explainers

(a) To estimate: The synthesis gas reaction on the process Concept introduction: In gasification process, carbon reacts with steam and produce carbon monoxide and hydrogen which are known as synthesis gas. This may either burned or subjected for further process to produce variety of chemicals.

(b) To estimate: The expression for molar flow rate for four outlet gas. Concept introduction: When moles of mixture pass the measurement point in one second, it is called molar flow rate which is denoted as n.

(c) To Estimate: The heat of formation of coal Concept introduction: The sum of internal energy and the product of the pressure and volume of a thermodynamic system are known as enthalpy

Want to see the full answer?

Chapter 9 Solutions

(a)

To estimate:

The synthesis gas reaction on the process

Concept introduction:

In gasification process, carbon reacts with steam and produce carbon monoxide and hydrogen which are known as synthesis gas. This may either burned or subjected for further process to produce variety of chemicals.

(b)

To estimate:

The expression for molar flow rate for four outlet gas.

Concept introduction:

When moles of mixture pass the measurement point in one second, it is called molar flow rate which is denoted as n.

(c)

To Estimate:

The heat of formation of coal

Concept introduction:

The sum of internal energy and the product of the pressure and volume of a thermodynamic system are known as enthalpy