Concept explainers
(a)
Interpretation:
Calculate the Henry’s law coefficient of oxygen and nitrogen.
Concept introduction:
According to Henry’s law, the amount of gas dissolved is proportional to its partial pressure. The proportionally constant is known as Henry’s law constant
(b)
Interpretation:
Calculate the flowrate of blood into the lungs.
Concept introduction:
According to Henry’s law, the amount of gas dissolved is proportional to its partial pressure. The proportionally constant is known as Henry’s law constant
(c)
Interpretation:
State the assumptions made in the calculation of Part (b).
Concept introduction:
According to Henry’s law, the amount of gas dissolved is proportional to its partial pressure. The proportionally constant is known as Henry’s law constant
Want to see the full answer?
Check out a sample textbook solutionChapter 6 Solutions
EBK ELEMENTARY PRINCIPLES OF CHEMICAL P
- Hydrochloric acid is sold as a concentrated aqueous solution. If the concentration of commercial HCl is 12.0 M and its density is 1.18 g/cm3, calculate the following: (a) the molality of the solution (b) the weight percent of HCl in the solutionarrow_forwardThe density of a 3.75 M aqueous sulfuric acid solution in a car battery is 1.225 g/mL. Express the concentration of the solution in molality, mole fraction H2SO2, and mass percentage of H2SO4.arrow_forward3. A 12.0 cm3 sample of liquid H2O (density 1.00 g.cm-3) is heated to 328 oC under an external pressure of 0.8 atm, conditions under which it vapourises: (i) Calculate the volume of the gas. (ii) Calculate the mass of the same volume (as in part i) of CO2 gas under the same conditions. (iii) Calculate temperature of that sample of CO2 (as in part ii) at 8.0 atm pressure in a 20.0 L container.arrow_forward
- Fluorocarbons (compounds that contain both carbonand fluorine) were, until recently, used as refrigerants.The compounds listed in the following table are all gasesat 25 °C, and their solubilities in water at 25 °C and 1atm fluorocarbon pressure are given as mass percentages.(a) For each fluorocarbon, calculate the molality of a saturatedsolution. (b) Which molecular property best predictsthe solubility of these gases in water: molar mass,dipole moment, or ability to hydrogen-bond to water?(c) Infants born with severe respiratory problems are sometimesgiven liquid ventilation: They breathe a liquid thatcan dissolve more oxygen than air can hold. One of theseliquids is a fluorinated compound, CF3(CF2)7Br. The solubilityof oxygen in this liquid is 66 mL O2 per 100 mL liquid.In contrast, air is 21% oxygen by volume. Calculate themoles of O2 present in an infant’s lungs (volume: 15 mL)if the infant takes a full breath of air compared to takinga full “breath” of a saturated solution of O2 in…arrow_forward5C. 2(b) Sketch the phase diagram of the system of NH/NH, given that the two substances do not form a compound; NH, freezes at -78 °C; N₂H, freezes at 2 °C; a eutectic is formed when the mole fraction of N H is 0.07; and the eutectic melts at -80 °C.arrow_forwardA mixture consiting of 1.000 mol H2O(g) and 1.000 mol CO(g) is placed ina reaction vessel of volume 10.00 L at 800. K. At equilibrium, 0.665 mol CO2(g) is present as a result of the reaction CO (g) + H2O (g)⇋ CO2(g)+H2(g). What are the equilibrium concentrations for all substances?arrow_forward
- The Henry's law constant for CO2(g)CO2(g) in water at 25 ∘C25 ∘C is 29.4 bar·M−129.4 bar·M−1. Estimate the concentration of dissolved CO2(g)CO2(g) in a carbonated soft drink pressurized with 2.152.15 bar of CO2(g)CO2(g).arrow_forwardA semi-permeable membrane separates the contents of cell. The concentration of sodium ions is 2.1 L.atm mol mol K.mol outside of the cell and 2.5 inside of the cell. The ideal gas constant R= 8.206 x 10 -2 L L and room temperature is about 20°C or 293 K. (a) Determine the osmotic pressure (in atm) and the tonicity of the solution surrounding a cell with radius of 0.013 mm at room temperature. П= (b) The solution surrounding the cell is O Hypotonic O Hypertonic O Isotonic atmarrow_forwardThe following table presents the solubilities of severalgases in water at 25 °C under a total pressure of gas andwater vapor of 1 atm. (a) What volume of CH4(g) understandard conditions of temperature and pressure is containedin 4.0 L of a saturated solution at 25 °C? (b) Thesolubilities (in water) of the hydrocarbons are as follows:methane < ethane < ethylene. Is this because ethyleneis the most polar molecule? (c) What intermolecularinteractions can these hydrocarbons have with water?(d) Draw the Lewis dot structures for the three hydrocarbons.Which of these hydrocarbons possess p bonds?Based on their solubilities, would you say π bonds aremore or less polarizable than s bonds? (e) Explain whyNO is more soluble in water than either N2 or O2. (f) H2S is more water-soluble than almost all the other gasesin table. What intermolecular forces is H2S likely to havewith water? (g) SO2 is by far the most water-soluble gasin table. What intermolecular forces is SO2 likely to havewith…arrow_forward
- 3. (a) At 10 °C, the vapour pressures of pure chloroform (CHCI;) and pure dichloromethane (CH2CI2) are 101 mmHg and 235 mmHg, respectively. Assume that a solution made by mixing CHCI3 and CH;Cl2 is ideal. ii. Given the following data for this solution: p (CH2C12) = 1.33 gcm³; p (CHC13) = 1.48 gcm3; partial molar volume of CH2C12 = 56.5 cm³mol·'; partial molar volume of CHC13 = 77.3 cm³mol'. Calculate AmixVarrow_forwarda) Calculate the volume (in L) occupied by 16 g of Carbon dioxide gas at a pressure of 99.7 x 103 Pa and a temperature of 100°C. (R= 8.314 JK1 mol-¹). What assumptions have you employed with this calculation? b) Predict whether the following liquid-liquid mixtures are miscible and explain your answer. c) 1. CH3NH3 and CH3CH2CH₂CH2CH₂CH₂CH₂CH3 ii. CH3CN and H₂O For the following pairs of functional groups, predict which would likely have the higher boiling point and justify your answer. i. Alcohol and Ketone ii. Ether and Aldehydearrow_forwardThe sealed containers of fizzy drinks contain dissolved CO2. This dissolved CO2 is in equilibrium with a small quantity of gaseous CO2 at the top of the container. The partial pressure of CO2 gas in a 250 cm3 can of fizzy drink is 3.0 atm at 25 0C. What is the concentration of CO2 in the fizzy drink?arrow_forward
- Chemistry & Chemical ReactivityChemistryISBN:9781337399074Author:John C. Kotz, Paul M. Treichel, John Townsend, David TreichelPublisher:Cengage LearningChemistry & Chemical ReactivityChemistryISBN:9781133949640Author:John C. Kotz, Paul M. Treichel, John Townsend, David TreichelPublisher:Cengage LearningChemistry: Principles and PracticeChemistryISBN:9780534420123Author:Daniel L. Reger, Scott R. Goode, David W. Ball, Edward MercerPublisher:Cengage Learning